Filter
Top Products
12-16 BRAKES
Master Cylinder
Rear Master Cylinde r Removal
•
Unscrew the brake hose banjo bolt [A] and brake hose
[B].
•
Remove:
Cotter Pin [C]
Joint Pin [D]
Bolts [E]
Foot Guard [F]
Rear Master Cylinder
•
Slide out the clamp [G].
•
Pull off the reservoir hose lower end [H], and drain the
brake fluid into a container.
Rear Master Cy linder I nstallation
•
Replace the cotter pin with a new one.
•
Replace the washers that are on each side of hose fitting
with new ones.
•
Tighten:
Torque - Rear Master Cylinder Mounting Bolts: 25 N·m (2.5
kgf·m, 18 ft·lb)
BrakeHoseBanjoBolt:25N·m(2.5kgf·m,18ft·lb)
•
Bleed the brake line (see Brake Line Bleeding).
•
Check the brake for good braking power, no brake drag,
and no fluid leakage.
Front Master Cylinder Disassemb ly
•
Refer to the Master Cylinder Rubber Parts Replacement
in the Periodic Maintenance chapter (see Master Cylinder
Rubber Parts Replacement in the Periodic Maintenance
chapter).
Rear Master Cylinder Disassembly
•
Refer to the Master Cylinder Rubber Parts Replacement
in the Periodic Maintenance chapter (see Master Cylinder
Rubber Parts Replacement in the Periodic Maintenance
chapter).
Master Cylinder Assembly
•
Refer to the Master Cylinder Rubber Parts Replacement
in the Periodic Maintenance chapter (see Master Cylinder
Rubber Parts Replacement in the Periodic Maintenance
chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com