Filter
Top Products
BRAKES 12-9
Brake Lever, Brake Pedal
•
Remove:
Cotter Pin [A]
Joint Pin [B]
Rear Brake Light Switch Spring [C]
Return Spring [D]
•
Remove the mounting bolt [E] and take out the brake
pedal.
Brake P edal Installation
•
Apply grease to the pivot shaft [A] and install the washer
[B].
•
Install:
Brake Pedal [C]
Washer [D]
Brake Pedal Bolt [E]
Torque - Brake Pedal Bolt: 8.8 N·m (0.90 kgf·m, 78 in·lb)
•
Hook the lower end of the rear brake light switch spring
[A] on the pedal hook.
○
Install the spring so that the hook turns outside.
•
Hook the upper end of the return spring [B] on the pedal
hook.
•
Replace the cotter pin with a new one.
○
Insert the cotter pin [A] and bend the pin ends [B].
•
Install the right footpeg bracket.
Torque - Front Footpeg Bracket Bolts: 25 N·m (2.5 kgf·m,
18 ft·lb)
○
Depress the brake pedal [A] and then align the bolts holes
of the master cylinder [B].
Torque - Rear Master Cylinder Mounting Bolts: 25 N·m (2.5
kgf·m, 18 ft·lb)
•
Check the brake pedal position (see Brake Pedal Position
Inspection).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com