Filter
Top Products
SUSPENSION 13-15
Front F ork
•
Screw the fork piston rod puller onto the end of the piston
rod.
Special Tool - Fork Piston Rod Puller, M10 × 1.0: 57001
-1298
•
Pull the puller up above the outer tube top.
•
Install the fork spring [A] with the smaller end facing [B]
upward.
•
Install:
Spring Seat
Collar
•
Screw the rod nut [B] onto the piston rod [A] as shown.
11 mm (0.43 in.) [C]
•
Check the distance [C] between the bottom end [A] of the
top plug and rebound damping adjuster [B] with a pair of
vernier caliper.
13 mm (0.51 in.) [C]
•
Set the fork spring compressor on the washer using the
outer tube as a guide.
Special Tools - Fork Spring Compressor: 57001-1587
Clamp: 57001-1626
NOTE
○
Set the clamps so that the cutout [A] of the upper side
does not fit the hole [B] of washer [C], pull up the outer
tube [D] to hold it by the clamps, and then tighten the
two bolts [E]. The outer tube is used as a guide.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com