Filter
Top Products
PERIODIC MAINTENANCE 2-33
Maintenance Procedure
Chain Guide Wear Inspection
•
Remove:
Swingarm (see Swingarm Removal in the Suspension
chapter)
•
Visually inspect the chain guide [A].
Replace the chain guide if it shows any signs of abnormal
wear or damage.
Brake System
Brake Fluid Leak (Brake Hose and Pipe) Inspection
•
Apply the brake lever or pedal and inspect the brake fluid
leak from the brake hoses [A] and fittings.
If the brake fluid leaked from any position, inspect or re-
place the problem part.
Brake Hose Damage and I nstallation Condition
Inspection
•
Inspect the brake hoses and fittings for deterioration,
cracks and signs of leakage.
○
The high pressure inside the brake line can cause fluid to
leak [A] or the hose to burst if the line is not properly main-
tained. Bend and twist the rubber hose while examining
it.
Replace the hose if any crack [B], bulge [C] or leakage is
noticed.
Tighten any brake hose banjo bolts.
Torq ue - Brake Hose Ba njo Bol ts: 25 N·m (2.5 kgf·m, 18
ft·lb)
•
Inspect the brake hose routing.
If any brake hose routing is incorrect, route the brake hose
according to Cable, Wire, and Hose Routing section in the
Appendix chapter.
Brake Operation Inspection
•
Inspect the operation of the front and rear brake by run-
ning the vehicle on the dry road.
If the brake operation is insufficiency, inspect the brake
system.
WARNING
When inspecting by running the vehicle, note a
surrounding traffic situation enough in the place of
safety.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com