Filter
Top Products
8-12 ENGINE REMOVAL/INSTALLATION
Engine Removal/Installation
•
Install the left [A] and right [B] engine bracket, following
the specified installing sequence.
○
First, install the adjusting collar [C] to the right engine
bracket [B].
○
Second, install the bolts [D] [E] [F] [G] temporally as
shown sequence [1 ∼ 8] in the figure.
○
Third, tighten the bolts [D] to the tightening sequence [1
∼ 3] shown.
Torque - Left Engine Bracket Bolts: 44 N·m (4.5 kgf·m, 32
ft·lb)
○
Forth, tighten the bolts [E] to the tightening sequence [5
∼ 7] shown.
Torque - Right Engine Bracket Bolts (M10, L = 30): 44 N·m
(4.5 kgf·m, 32 ft·lb)
○
Fifth, tighten the bolt [F].
Torque - Left Engine Bracket Bolt: 44 N·m (4.5 kgf·m, 32
ft·lb)
○
Sixth, remove the bolt [G] temporally, and using the
hexagon wrench, turn the adjusting collar [C] until the
clearance [H] between the cylinder head and collar come
to0mm(0in.).
○
Lastly, reinstall the bolt [G], and tighten it.
Torque - Right Engine Bracket Bolt (M10, L = 35): 44 N·m
(4.5 kgf·m, 32 ft·lb)
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com