Filter
Top Products
CLUTCH 6-9
Clutch Cover
Clutch Cove r Assembly
•
Replace the needle bearings and oil seal with new ones.
NOTE
○
Install the needle bearings so that the manufacture’s
make face out.
•
Install the needle bearings [A] and oil seal [B] position as
shown.
○
Press the lower bearing, do not protrude from the boss
[C] of the clutch cover.
○
Press the upper bearing so that the bearing surface [D] is
flush with the housing end of clutch cover [E].
○
Press the oil seal until the bottom.
•
Replace the O-ring [A] of the oil filler plug [B] with a new
one.
•
Apply engine oil to the new O-ring.
•
Install the oil filler plug.
Torque - Oil Filler Plug: Hand-tighten
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com