Filter
Top Products
13-24 SUSPENSION
Swingarm
Swingarm Installation
•
Apply plenty of grease to the lip [A] of the oil seals.
•
Install the collar.
•
Place the adjusting collar [A] into the frame [B] as shown.
•
Insert the pivot adjusting shaft [A] into the frame from the
right side.
•
Tighten the pivot shaft so that the clearance between the
adjusting collar [B] and the ball bearing [C] come to 0 mm
(0 in.).
Torque - Swingarm Pivot Adjusting Shaft: 20 N·m (2.0
kgf·m, 15 ft·lb)
•
Tighten the adjusting collar locknut [A] w ith the swingarm
pivot nut wrench [B].
Special Tool - Swingarm Pivot Nut Wrench: 57001-1597
Torque - Swingarm Pivot Adjusting Collar Locknut: 98 N·m
(10.0 kgf·m, 72 ft·lb)
•
Tighten the swingarm pivot shaft nut [A].
Torque - Swingarm Pivot Shaft Nut: 108 N·m (11.0 kgf·m,
80 ft·lb)
•
Install the removed parts (see appropriate chapters).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com