Filter
Top Products
3-88 FUEL SYSTEM (DFI)
Immobilizer Amplifier (Service C ode 35)
Antenna Resistance Inspection
•
Remove the left upper inner fairing (see Upper Inner Fair-
ing Removal in the Frame chapter).
•
Disconnect the antenna lead connector [A].
•
Measure the resistance of the antenna coil in the ignition
switch as follows.
Antenna Resistance
Connections to Antenna
Meter → BK lead
Meter → BK lead
Standard: About 0.6 ∼ 0.9 Ω
If the resistance is out of the standard range, replace the
ignition switch.
Amplifier Inpu t Voltage Inspection
NOTE
○
Be sure the battery is fully charged.
•
Turn the ignition switch OFF.
•
Remove the left middle fairing (see Middle Fairing Re-
moval in the Frame chapter).
•
Connect a digital meter to the amplifier connector [A], us-
ing the needle adapter set.
Special Tool - Needle Adapter Set: 57001-1457
Amplifier Input Voltage
Connections to Connector
Meter (+) → BR/W lead
Meter (–) → BK/Y lead
•
Measure the input voltage with the engine stopped, and
with the connector joined.
•
Turn the ignition switch ON.
Input Voltage
Standard:
Battery Voltage
•
Turn the ignition switch OFF.
If the reading is out of the range, check the wiring (see
wiring diagram in next section).
If the reading and antenna resistance are good, replace
the amplifier (see Immobilizer System Parts Replacement
in the Electrical System chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com