Filter
Top Products
FUEL SYSTEM (DFI) 3-127
Throttle Body Assy
•
After removing the throttle body assy, stuff pieces of lint
-free, clean cloths into the throttle body assy holders.
CAUTION
If dirt gets into the engine, excessive engine wear
and possible engine damage will occur.
If the throttle body assy is to be disassembly, loosen the
air cleaner housing holder clamp bolts [A], and remove
the air cleaner housing holder [B].
Throttle Body Assy Installation
If the air cleaner housing holder [A] was removed, install
it.
○
Install the holder clamp bolts [B] in the direction as shown.
Bolt Heads [C]
Torque - Air Cleaner Housing Holder Clamp Bolts: 2.0 N·m
(0.20 kgf·m, 18 in·lb)
•
Install the holder clamp bolts [A] in the direction as shown.
Bolt Heads [B]
•
Tighten:
Torque - Throttle Body Assy Holder Clamp Bolts: 2.0 N·m
(0.20 kgf·m, 18 in·lb)
•
Run the leads and hoses as shown in the Cable, Wire,
and Hose Routing section of the Appendix chapter.
•
When installing the fuel hose, refer to Fuel Tank Installa-
tion.
•
Adjust:
Throttle Grip Free Play (see Throttle Control System In-
spection in the Periodic Maintenance chapter)
Idle Speed (see Idle Speed Adjustment in the Periodic
Maintenance chapter)
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com