Filter
Top Products
FINAL DRIVE 11-15
Sprocket, Coupling
Rear Sprocket Warp Inspection
•
Raise the rear wheel off the ground (see Rear Wheel
Removal in the Wheels/Tires chapter) so that it will turn
freely.
•
Set a dial gauge [A] against the rear sprocket [B] near the
teeth as shown, and rotate [C] the rear wheel to measure
the sprocket runout (warp). The difference between the
highest and lowest dial gauge readings is the amount of
runout (warp).
If the runout exceeds the service limit, replace the rear
sprocket.
Rear Sprocket Warp
Standard: 0.4 mm (0.016 in.) or less
Service Limit: 0.5 mm (0.02 in.)
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com