Filter
Top Products
ELECTRICAL SYSTEM 16-31
Charging System
Alternator Cover Removal
•
Remove:
Left Middle Fairing (see Middle Fairing Removal in the
Frame c hapter)
Coolant Reserve Tank (see Coolant Reserve Tank Re-
moval in the Cooling System chapter)
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Alternator Lead Connector [A]
For the Europe Models
•
Remove:
Bolts [A]
Clamp [B]
Cover [C]
For the other than Europe Models
•
Remove:
Bolts [A]
Clamp [B]
Cover [C]
Alternator Cover Installation
•
Apply silicone sealant to the alternator lead grommet and
crankcase halves mating surface [A] on the front and rear
sides of the cover mount.
Sealant - Kawasaki Bond (Silicone Sealant): 92104-0004
•
Check that dowel pins [B] are in place on the crankcase.
•
Install a new gasket and the alternator cover.
•
Tighten:
Torque - Alternator Cover Bolts: 10 N·m (1.0 kgf·m, 89 in·lb)
Stator Coil Removal
•
Remove:
Alternator Cover (see Alternator Cover Removal)
Holding Plate Bolt [A] and Plate
Alternator Lead Grommet [B]
Stator Coil Bolts [C]
•
Remove the stator coil [D] from the alternator cover.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com