Filter
Top Products
FUEL SYSTEM (DFI) 3-133
Air Line
•
Install the housing on the holder then insert the ducts.
○
Apply a soap and water solution [A] to the ducts for easy
installation.
•
Insert the projections [B] of the housing in the holes [C] of
the ducts.
•
Tighten:
Torque - Air Cleaner Housing Mounting Bolts: 7.0 N·m
(0.70 kgf·m, 62 in·lb)
•
Install the air cleaner element (see Air Cleaner Element
Replacement in the Periodic Maintenance chapter).
Air Cleaner Ho using Disasse mbly
•
Remove:
Air Cleaner Housing (see Air Cleaner Housing Removal)
Air Cleaner Housing Screws [A]
Lower Housing [B]
Duct Holder Screws [C]
Ducts and Duct Holders
Filter
Air Cleaner Housing Assembly
•
Install:
Ducts [A] and Duct Holders [B]
Filter [C]
If the filter is dirt, clean the filter in cleaning solvent, and
then dry it with compressed air or squeeze it.
•
Insert the seal [A] into the groove in the lower housing [B].
•
Apply liquid gasket to the mesh patterns [C] on the lower
housing.
Sealant - Kawasaki Bond (Liquid Gasket - Black): 92104
-0002
○
Wipe off any protruding liquid gasket.
•
Fit the upper and lower housings, and tighten the screws
securely.
Oil Draining
A drain hose is connected to the bottom of the air cleaner
part to drain water or oil accumulated in the cleaner part.
•
Remove the left lower fairing (see Lower Fairing Removal
in the Frame chapter).
•
Visually check the drain hose end [A], if the water or oil
accumulates in the hose.
If any water or oil accumulates in the hose , remove the
plug [B] from the drain hose and drain it.
WARNING
Be sure reinstall the plug in the drain hose after
draining. Oil on tires will make them slippery and
can cause an accident and injury.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com