Filter
Top Products
SUSPENSION 13-13
Front F ork
•
Screw the adjust nut [A] onto the compression shaft as
shown.
20 mm (0.79 in.) [B]
•
Screw the locknut [C].
•
Set the other side compression shaft same process.
•
Screw in one side nut [A] come out the piston rod nut.
•
Holding the piston rod nut with a wrench [A], remove the
top plug [B] from the piston rod.
•
Remove:
Washer [A]
Collar [B]
Rebound Damping Adjuster Rod [C]
Fork Spring [D]
•
Drain the fork oil into a suitable container.
○
Pump the piston rod [B] up and down at least ten times to
expel the oil from the fork.
Special Tool - Fork Piston Rod Puller, M10 × 1.0 [A]: 57001
-1298
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com