Filter
Top Products
7-16 ENGINE LUBRICATION SYSTEM
Oil Cooler
Oil Cooler/Oil Filter Case Installation
•
Replace the O-ring [A] with a new one.
•
Apply grease to the new O-ring.
If the oil filter pipe [B] was removed, install it.
○
Apply a non-permanent locking agent to the threads of
the oil filter pipe, and tighten it.
Torque - Oil Filter Pipe: 35 N·m (3.6 kgf·m, 26 ft·lb)
•
Apply non-permanent locking agent to the threads of the
oil cooler/oil filter case mounting bolts, and tighten it.
Torque - Oil Cooler/Oil Filter Case Mounting Bolts: 20 N·m
(2.0 kgf·m, 15 ft·lb)
•
Install:
Oil Cooler (see Oil Cooler Installation)
Oil Filter (see Oil Filter Replacement in the Periodic
Maintenance chapter)
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com