9-12 CRANKSHAFT/TRANSMISSION
Crankcase Splitting
•
Apply a non-permanent locking agent to the treads of the
breather plate bolts [A] and tighten it.
Torq ue - Breather P la te Bolts: 1 0 N·m (1.0 kgf·m, 89 in·lb)
•
Install the following in the upper crankcase.
Output Shaft [A] (see Transmission Shaft Installation)
Crankshaft [B] (see Crankshaft Installation)
Pistons and Connecting Rods [C] (see Connecting Rod
Installation)
Camshaft Chain [D] (see Camshaft Chain Removal/In-
stallation in the E ngine Top End chapter)
Dowel Pins [E]
•
Install the following in the lower crankcase.
Drive Shaft [A] (see Transmission Installation)
Shift Drum [B] (see Shift Drum and Fork Installation)
Shift Forks [C] and Shift Rods (see Shift Drum and Fork
Installation)
•
Before fitting the lower case on the upper case, check the
following.
○
Check to see that the shift drum cam [A] and transmission
gears are in the neutral position [B].
○
Be sure hang the camshaft chain on the crankshaft.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com