SUSPENSION 13-23
Swingarm
Swingarm Removal
•
Remove:
Rear Wheel (see Rear Wheel Removal in the
Wheels/Tires chapter)
Middle Exhaust Pipe (see Middle and Rear Exhaust Pipe
Removal in the Engine Top End chapter)
Engine Sprocket (see Engine Sprocket Removal in the
Final Drive chapter)
Bolts [A]
Chain Cover [B]
Inner Fender [C]
•
Remove:
Bolt [A]
Brake Hose Clamp [B]
•
Remove:
Upper Tie-Rod Nut and Bolt [A]
Rear Shock Absorber [B] (see Rear Shock Absorber Re-
moval)
•
Unscrew the swingarm pivot shaft nut [C].
•
Loosen the swingarm pivot collar locknut [A] using the nut
wrench [B].
Special Tool - Swingarm Pivot Nut Wrench: 57001-1597
•
Unscrew the swingarm pivot shaft [A] few times.
○
Turn out the swingarm pivot adjusting collar.
•
Pull out the pivot shaft from the right side of the motorcycle
and remove the swingarm.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com