Filter
Top Products
APPENDIX 17-11
Cable, Wire, and Hose Routing
1. Left City Light Connector
2. Meter Connector
3. Clamp
4. Headlight Connector
5. Clamp
6. Run the fan motor lead connector above the main harness.
7. Immobilizer Amplifier
8. Joint Connector for the stick coil and air switching valve leads (Install it into the bracket).
9. Clamp (The clamp attached on the main harness.)
10. Fuel Pump Connector
11. Vehicle-down Sensor
12. Clamp (The clamp attached on the main harness.)
13. Tail/Brake Light Connector
14. Through the license plate light lead into the rear fender hole.
15. License Plate Light Connector
16. Run the leads to the cutted space of the rear fender rear (Left and Right).
17. Trim
18. Run the battery negative (–) cable above the main harness.
19. Do not pinch the reserve tank.
20. Clamps
21. Clamp the oxygen sensor #1 connector.
22. Clamp the oxygen sensor #2 connector.
23. Sidestand Switch Connector
24. Reserve Tank Overflow Hose
25. Install the clamp into the bracket from inside (The clamp attached on the main harness.).
26. Left Turn Signal Light Connector
27. Horn
28. Joint Connector (Ignition Switch Lead and Left Switch Housing Lead)
29. Clamp the ignition switch lead and left switch housing lead.
30. Tape (Gray)
31. Clamp
32. Within 30 mm (1.2 in.)
33. Run the gear position switch harness as shown before installing the water pump cover.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com