Filter
Top Products
3-104 FUEL SYSTEM (DFI)
Oxygen Sensor #2-not activated (ServiceCode83)-EuropeModels
•
Connect the following parts temporary.
Fuel Pump Lead Connector [A]
Extension Tube [B]
Special Tool - Extension Tube: 57001-1578
•
Turn the ignition switch ON.
•
Start the engine, and let it idle.
•
Measure the output voltage of the sensor with the con-
nector joined.
Oxygen Sensor Output Voltage (with Plugs)
Standard:
0.45 ∼ 2.5 V
•
Next, remove the plugs from the fittings [A] with idling.
•
Measure the output voltage of the sensor with the con-
nector joined.
Oxygen Sensor #2 Output Voltage (without Plugs)
Standard:
0.05 ∼ 0.45 V
If the reading is within range (with plugs: 0.45 ∼ 2.5 V,
without plugs: 0.05 ∼ 0.45 V), the oxygen sensor is good.
If the reading is without range, replace the oxygen sensor.
•
Remove the needle adapter set, and apply silicone
sealant to the seals of the connector for waterproofing.
Sealant - Kawasaki Bond (Silicone Sealant): 56019-120
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com