Filter
Top Products
APPENDIX 17-15
Cable, Wire, and Hose Routing
1. Clamp
2. Air Cleaner Drain Hose
3. Breather Hose
4. Joint Connector (Water Temperature Sensor Lead, Gear Position Sensor Lead, Speed Sensor
Lead, and Oil Pressure Switch Lead)
5. Right Side
6. Front
7. Rear
8. Left S ide
9. Clamp
10. Clamp
11. R adiator Hose
12. Clamp
13. Face the paint mark to the front.
14. Clamp
15. Water Hose (To the Oil Cooler)
16. Sidestand Switch Lead
17. Bracket
18. Clamp for the reserver tank overflow hose, oxygen sensor leads, air cleaner drain hose, and
sidestand switch lead (Other than US, CA, CAL, AU, and MY Model only)
19. Oxygen Sensor Connectors (Connect to the main harness after through the sensor leads under
the bracket.)
20. Clamp the sidestand switch lead and tubes.
21. US, C A, CAL, AU, and MY Model only
22. Clamp
23. Reserve Tank Overflow Hose
24. Water Pipe
25. Radiator Hose (Face the white mark outside.)
26. Reserve Tank Overflow Hose
27. Radiator Return Hose
28. Radiator Overflow Hose
29. Clamp
30. Clamps
31. Radiator Coolant Return Hose
32. Starter Motor Cable
33. Run the starter motor cable under the adjusting collar.
34. Approx. 45°
35. Engine Ground Cable
36. Alternator Lead Connector
37. Speed Sensor Connector
38. Water Temperature Sensor Connector
39. Through the alternator harness and gear position sensor harness into the heat cover hole.
40. Clamp
41. Front
42. Paint Mark (White)
43. Install the clamps as shown illustration noting to the direction of clip.
44. Through the radiator coolant return hose inside the ignition coil connector, upside of the main
harness, and under the upper inner fairing bracket.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com