Filter
Top Products
16-46 ELECTRICAL SYSTEM
Ignition System
Camshaft Position Sensor Peak Voltage
Inspection
•
Disconnect the camshaft position sensor connector (see
Camshaft Position Sensor Removal).
•
Set the hand tester [A] to the 10 V DC range.
•
Connect the peak voltage adapter [B] to the hand tester
and camshaft position sensor leads in the terminals.
Special Tool - Hand Tester: 57001-1394
Peak Voltage Adapter: 57001-1415
Type: KEK-54-9-B
Connections:
Camshaft Position
Sensor Terminal
Adapter Hand Tester
White/Yellow [C]
←
Red
→
(+)
Yellow [D]
←
Black
→
(–)
•
Turn the ignition switch and engine stop switch ON.
•
Pushing the starter button, turn the engine 4 ∼ 5sec-
onds with the transmission gear in neutral to measure the
camshaft position sensor peak voltage.
•
Repeat the measurement 5 or more times.
Camshaft Position Sensor Peak Voltage
Standard:
0.4 V or more
If the peak voltage is lower than the standard, inspect the
camshaft position sensor.
Interlock O peration Inspection
•
Using the stand [A], raise the rear wheel off the ground.
1st Check
•
Start the engine to the following conditions.
Condition:
Transmission Gear → 1st Position
Clutch Lever → Release
Sidestand → Down or Up
○
Turn the ignition switch ON and push the starter button.
○
Then the starter motor should not turn when the starter
system circuit is normality.
If the engine is start, inspect the starter lockout switch,
gear position switch, and relay box.
If their parts are normality replace the ECU.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com