FINAL DRIVE 11-13
Sprocket, Coupling
Coupling In stallation
•
Grease the following and install the coupling.
Coupling Grease Seal Lips [A]
Coupling Internal Surface [B]
•
Apply grease to the O-ring [A].
•
Install the collar [B].
Coupling Bearing Remo val
•
Remove:
Coupling
Grease Seal
Circlip [A]
Special Tool - Inside Circlip Pliers [B]: 57001-143
•
Remove the bearing [A] by tapping from the wheel side.
Special Tool - Bearing D river Set [B]: 57001-1129
Coupling Bearing Installation
•
Replace the bearing with a new one.
•
Press in the bearing [A] until it is bottomed.
Special Tool - Bearing D river Set [B]: 57001-1129
•
Pack the bearing with high temperature grease.
•
Replace the circlip with a new one.
Special Tool - Inside Circlip Pli ers : 570 01-143
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com