Filter
Top Products
FUEL SYSTEM (DFI) 3-51
Main Throttle Sensor (Service Code 11)
•
Remove the throttle body assy temporarily (see Throttle
Body Assy Removal).
•
Disconnect the main throttle sensor connector [A].
•
Connect the harness adapter [A] between the harness
connector and main throttle sensor connector.
•
Connect a digital meter to the harness adapter leads.
Special Tool - Throttle Sensor Setting Adapter: 57001
-1538
Main Throttle Sensor Input Voltage
Connections to Adapter
Meter (+)→ W (sensor BL) lead
Meter (–)→ BK (sensor BR/BK) lead
•
Reinstall the throttle body assy (See Throttle Body Assy
Installation).
•
Measure the input voltage with the engine stopped, and
with the connector joined.
•
Turn the ignition switch ON.
Input Voltage at Sensor
Standard: DC 4.75 ∼ 5.25 V
•
Turn the ignition switch OFF.
If the reading is out of the range, check the wiring (see
wiring diagram in this section).
If the reading is good, check the output voltage of the
sensor.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com