Filter
Top Products
15-18 FRAME
Fenders
•
Pull out the rear fender rear [A] assembled turn signal
lights and license plate light downward.
Rear Fender Rear Installation
•
Install the harness clamp in accordance with Harness
Routing section in Appendix chapter.
Rear Fender Front Removal
•
Remove:
Seat Cover (see Seat Cover Removal in the chapter)
Middle Exhaust Pipe (see Middle and Rear Exhaust Pipe
Removal in the Engine Top End chapter)
Rear Fender (see Rear Fender Rear Removal)
Battery [A] (see Battery Removal in the Electrical System
chapter)
•
Remove the fuse box [B] from the rear fender front.
•
Remove:
Starter Relay [C] (see Starter Relay Inspection in the
Electrical System chapter)
Relay Box [D] (see Relay Box Removal in the Electrical
System chapter)
Turn Signal Relay [E] (see Turn Signal Relay Inspection
in the Electrical System chapter)
ECU (see ECU Removal in the Fuel System (DFI) chap-
ter)
Fuel Pump Connector [F] (see Fuel Tank Removal in the
Fuel System (DFI) chapter) and Bracket
Exhaust Butterfly Valve Actuator [G] (see Exhaust But-
terfly Valve Actuator Removal in the Fuel System (DFI)
chapter)
Owner’s Tool [H]
Atmospheric Pressure Sensor [I] (see Atmospheric
Pressure Sensor section in the Fuel System (DFI)
chapter)
Vehicle-down Sensor [J] (see Vehicle-down Sensor Re-
moval in the Fuel System (DFI) chapter)
Bolts [K]
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com