Filter
Top Products
6-14 CLUTCH
Clutch
•
Install the following as shown.
Friction Plates (9) [A]
Steel Plates (9) [B]
Spring Seat [C]
Spring [D]
○
Install the spring seat and spring between first steel plate
and second steel plate.
CAUTION
If new dry friction plates and steel plates are in-
stalled, apply engine oil to the surface of each plate
to avoid clutch plate seizure.
•
Install the last friction plate [A] fitting the tangs in the
grooves in the housing as shown.
•
Apply molybdenum disulfide grease to the pusher end [A].
•
Install the pusher [B] to the drive shaft direction as shown.
•
Apply engine oil to the sliding surfaces of the bearing [A].
•
Align the grooves [B] of the spring plate [C] to the grooves
[D] of the sub clutch hub [E] to install the spring plate on
the sub clutch hub.
•
Install the clutch springs and spring holders, and tighten
the clutch spring bolts.
Torque - Clutch Spring Bolts: 11 N·m (1.1 kgf·m, 97 in·lb)
•
Install the clutch cover (see Clutch Cover Installation).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com