Filter
Top Products
SUSPENSION 13-27
Tie-Rod, Rocker Arm
Tie-Rod Removal
•
Remove:
Lower Fairings (see Lower Fairing Removal in the Frame
chapter)
Middle Exhaust Pipe (see Middle and Rear Exhaust Pipe
Removal in the Engine Top End chapter)
•
Squeeze the brake lever slowly and hold it with a band
[A].
•
Using the jack, raise the rear wheel off the ground.
Special Tools - Jack: 57001-1238
Jack Attachment: 57001-1608
•
Remove:
Upper Tie-Rod Bolt and Nut [A]
Lower Tie-Rod Bolt and Nut [B]
Tie-Rods [C]
Tie-Rod Installation
•
Apply grease to the inside of the oil seals.
•
Install the tie-rods so that the marked side [A] faces the
bolts and nuts.
•
Tighten:
Torque - Tie-Rod Nuts: 59 N·m (6.0 kgf·m, 44 ft·lb)
Rocker Arm Removal
•
Remove:
Lower Fairings (see Lower Fairing Removal in the Frame
chapter)
Middle Exhaust Pipe (see Middle and Rear Exhaust Pipe
Removal in the Engine Top End chapter)
•
Squeeze the brake lever slowly and hold it with a band.
•
Using the jack, raise the rear wheel off the ground.
Special Tools - Jack: 57001-1238
Jack Attachment: 57001-1608
•
Remove:
Lower Rear Shock Absorber Bolt and Nut [A]
Lower Tie-Rod Bolt and Nut [B]
Rocker Arm Bolt and Nut [C]
Rocker Arm [ D]
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com