Filter
Top Products
3-20 FUEL SYSTEM
Carburetor
•
Fit the projection [A] of the vacuum piston diaphragm in
the recess [B] of the body.
•
After installing the upper chamber cover, check to make
sure that the vacuum piston moves smoothly in the car-
buretor body.
Carburetor Separation
•
Remove:
Carburetor (see Carburetor Removal)
Screws [A]
Fuel Hose Fittings [B]
•
Remove:
Cotter Pins [A], Collars and Washers
Link Arm [B]
•
Remove:
Link Case Screws [A]
Link Case [B]
•
Separate the Carburetors.
Carburetor Joining
•
Install link case and tighten link case screws.
•
Apply grease to the link pins [A].
•
Install the link arm as shown.
Washers [ B]
Collars [C]
Link Arm [D]
Cotter Pins [E]
•
Bend the ends of the cotter pins.
•
Install the fuel hose fittings, and tighten the screws.