Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
12-34 FIN AL DRIVE
Front Final Gear Case
Front Final Gear Case Oil Level Inspection
Park the vehicle so that it is level, both side-to-side and
front-to-rear.
Remove the filler cap.
CAUTION
Be careful not to allow any dirt or foreign materials
to enter the gear case.
Check the oil level. The oil level should come to the bot-
tom of the filler opening [A].
If it is insufficient, first check the front final gear case for
oil leakage, remedy it if necessary, and add oil through
the filler opening. Use the same type and brand of oil that
is already in the final gear case.
Be sure the O-ring is in place, and tighten the filler cap.
Apply grease to the O-ring.
Torque - Oil Filler Cap: 29 N· m (3.0 kgf·m, 22 ft·lb)
Front Final Gear Case Oil Change
Refer to the Front Final Gear Case Oil Change in the Pe-
riodic Maintenance chapter.
Variable Differential Control Lever Play Inspection
Refer to the Variable Differential Control Lever Play In-
spection in the Periodic Maintenance chapter.
Variable Differential Control Lever Play Adjustment
Refer to the Variable Differential Control Lever Play Ad-
justment in the Periodic Maintenance chapter.
Variable Differential Control Lever Removal
Remove:
Handlebar Cover
Plate Bolt [A]
Cable Stopper Plate [B]
Variable Differential Control Lever Bolt [C], Washer and
Collar
Variable Differential Control Lever [D]
Variable Differential Control Cable Upper End
Variable Differential Control Lever Installation
Install:
Variable Differential Control Cable Upper End
Variable Differential Control Lever [A]
Apply a non-permanent locking agent to the variable dif-
ferential control lever bolt [B].
Install:
Variable Differential Control Lever Bolt, Washer [C] and
Collar [D]
Tighten:
Install:
Cable Stopper Plate [E]
Plate Bolt [F]
Check the variable differential control lever play (see Vari-
able Differential Control Lever Play Inspection in Periodic
Maintenance chapter).