Filter
Top Products
12-42 FIN AL DRIVE
Front Final Gear Case
•
Apply engine oil to the needle bearing [A].
•
Install:
Needle Bearing
Outer Disc [B]
•
Apply engine oil to the variable front differential control
shaft [A].
•
Install the shaft and spring [B] in the front final gear case
left cover [C] as shown.
•
Turn the shaft counterclockwise and insert the tab [A] of
the shift shaft into the groove [B] of the cam plate.
•
Install:
Front Final Gear Case Left Cover [C]
•
Apply a non-permanent locking agent to the cover bolts [1
∼ 4], and tighten them following the tightening sequence
as shown.
Torque - Front Final Gear Case Left Cover Bolts (M6)
[1 ∼ 8]: 9.8 N·m ( 1.0 kgf·m, 87 ft·lb)
[1 ∼ 4] L = 60 mm (2.4 in.)
[5 ∼ 8] L = 30 mm (1.2 in.)
•
Apply grease to the oil seal lip [A].
•
Press the oil seal [B] in the coupling [C] to the specified
position as shown.
[D] 1 mm (0.04 in.)
Special Tools - Oil Seal Driver, 18.5: 57001-1505
Driver Holder: 57001-1132
NOTE
○
57001-1132 is included in Bearing Driver Set, 57001
-1129.