Filter
Top Products
FINAL DRIVE 12-35
Front Final Gear Case
Variable Differential Control Cable Installation
•
Lubrication the variable differential control cable before
installation.
•
Route the cable correctly according to the Appendix chap-
ter.
WARNING
Operation with an improperly adjusted, incorrectly
routed, or dam aged cable could result in an unsafe
operating condition.
•
Tighten:
To rque - Variable Differential Control Cable Locknut [A]: 17
N·m (1.7 kgf·m, 12 ft·lb)
•
Check the variable differential control lever play (see Vari-
able Differential Control Lever Play Inspection in Periodic
Maintenance chapter).
Variable Differential Cont r ol Cable Lubrication
Whenever the variable differential control cable is re-
moved, lubricate the cable as follows:
•
Apply a small amount of multi-purpose grease to the cable
(both ends).
•
Lubricate the cable with a penetrating rust inhibitor
through the pressure cable luber.
Variable Differential Control Cable Inspection
•
With the variable differential control cable disconnected at
both ends, the cable should move freely within the cable
housing.
If the cable does not move freely after lubricating, if the
cable is frayed, or if the housing is kinked, replace the
cable.
Front Final G ear Case Removal
•
Drain the gear case oil (see Front Final Gear Case O il
Change in Periodic Maintenance chapter).