Filter
Top Products
STEERING 15-13
Steering Maintenance
Steering Knuckle Bearing Inspection
CAUTION
Do not remove any bearings for inspection.
•
Remove the steering knuckle (see Steering Knuckle Re-
moval).
•
Turn [A] the bearing back and forth while checking for
roughness or binding.
If roughness or binding is found, replace the bearing.
•
Examine the bearing seal [B] for tears or leakage.
If the seal is torn or is leaking, replace the bearing.
Tie-rod End Inspection
•
Inspect each spherical bearing [A].
If roughness, excessive play, or seizure is found, replace
the tie-rod end.
•
Inspect each boot [B].
If damage, wear or deterioration is found, replace the tie
-rod end.
Steering Knuckle Joint Inspection
•
Inspect each spherical bearing [A].
If roughness, excessive play, or seizure is found, replace
the steering knuckle joint.
•
Inspect each boot [B].
If damage, wear or deterioration is found, replace the
steering knuckle joint.