Filter
Top Products
17-46 ELECTRICAL SYSTEM
Electric Starter System
•
Install:
Starter Motor [A]
Clamp [B] (as shown)
Starter Motor Cable [C]
•
Tighten:
Torque - Starter Motor Mounting Bolts: 8.8 N ·m (0.90 kgf·m,
78 in·lb)
Starter Motor Terminal Nut: 4.9 N·m (0.50 kgf·m,
43 in·lb)
•
Apply grease to the O-ring [D] in the joint duct [E].
•
Install:
Joint Duct and Collars [F]
Clamp [G] (as shown)
•
Tighten:
Torque - Joint Duct Bolts [H]: 8.8 N·m (0.90 kgf·m, 78 in·lb)
Starter Motor Disassem bly
•
Remove:
Starter Motor Bolts [A], Washers and O-rings
Left End Cover [B]
Right End Cover [C]
Yoke [D]
•
To remove the brush plate assembly [A], remove the ter-
minal nut [B].
•
Hold the brush spring [A] with needle nose pliers, and pull
the brush [B] off the holder.