Filter
Top Products
12-44 FIN AL DRIVE
Front Final Gear Case
Ring Gear Disassembly
•
Remove:
Ring Gear Assembly (see Front Final G ear Case Disas-
sembly)
Ring G ear Bolts [A]
Ring Gear [B]
•
Remove:
Differential Gear Case Cover [A]
Right Side G ear (16T) [B]
Pins [C]
Spider Gear Shaft [D]
Spider Gears (10T) [E]
Left Side Gear (16T) [F]
Left Differential Gear Case [G]
Ring Gear Assembly
•
Press the bearing [A] on the left differential gear case [B]
until it is bottomed.
•
Apply engine oil [C] to the spider gears and the spider
gear shaft.
•
Apply molybdenum disulfide grease [D] to the left side
gear (16T) [E].
•
Install:
Left Side Gear (16T)
Spider Gears (10T) [F]
Spider Gear Shaft [G] and Pins [H]
•
Apply engine oil [A] to the spider gears.
•
Apply molybdenum disulfide grease [B] to the right side
gear (16T) [C].
•
Install:
Right Side Gear (16T)
Differential Gear Case Cover [D]
Ring Gear [E]
•
Apply a non-permanent locking agent (Three Bond:
TB2471 Blue) to the ring gear bolts [F], and tighten them.
To rque - Ring Gear Bolts: 57 N·m (5.8 kgf·m, 42 ft·lb)
NOTE
○
Keep the ring gear assembly at more than 20°C (68°F)
for six hours after tightening the bolts.