Filter
Top Products
12-32 FIN AL DRIVE
Front Axle
•
Install the new retaining ring [ A] so that the opening [B] is
aligned with one of the projections [C].
•
Tighten the small band.
•
Squeeze the remaining special grease [A] into the inboard
joint boot [B].
•
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
•
Hold the axle at this setting.
Standard Length of Assembling:
Right Front Axle:
161.1 mm (6.34 in.) [A]
Left Front Axle: 169.1 mm (6.66 in.) [A]
•
Open the edge of the boot in order to eqalize the air pres-
sures.
•
Tighten the large band [ A] and bend the tangs securely to
hold down the end of the band.
Maximum Outside Diameter of Band: 69 mm (2.72 in.)
(After tightening the outside diameter)