Filter
Top Products
ELECTRICAL SYSTEM 17-41
Ignition System
Vehic le-down Sensor Removal
CAUTION
Never drop the vehicle-down sensor, especially on
a hard surface. Shock to the sensor can damage it.
•
Remove:
Rear Fender (see Frame chapter)
Vehicle-down Sensor Lead Connector [A]
Screws [B]
Vehicle-down Sensor [C]
Vehicle-down Sensor Installation
•
Install the vehicle-down sensor [A] so that the sensor lead
base faces forward [B], and the arrow m ark [C] on the
sensor points upward.
•
Tighten the screws securely.
WARNING
Incorrect installation of the vehicle-down sensor
could cause sudden loss of engine power. The
rider could lose balance during certain riding situ-
ations, like leaning over in a turn, with the potential
for an accident resulting in injury or death. Ensure
that the down sensor is held in place by the sensor
brackets.
Vehicle-down Sensor Inspection
NOTE
○
Be sure the battery is fully charged.
Vehicle-down Sensor Power Source Voltage
•
Remove:
Seat (see Frame chapter)
Vehicle-down Sensor Lead Connector
•
Connect:
Vehicle-down Sensor Lead Connector [A] (harness side)
Digital Volt M eter [B]
I. Connections to Connector (12 V circuit)
Meter (+) → Connector BR Lead [C]
Meter (–) → Connector BK/Y Lead [D]
•
Turn the ignition switch ON, and measure the power
source voltage.
Vehicle-down Sensor Power Source Voltage
Standard:
Battery Voltage
•
Turn the ignition switch OFF.
If there is no battery voltage, check the following:
Main Fuse 30 A
Ignition Switch
Wiring for Vehicle-down Sensor Power Source