15-8 STEERING
Steering
•
Hold the flat surfaces [A] of the t ie-rod end with a thin
wrench [B], and remove the tie-rod end nut [C] and wash-
ers.
•
Tap the tie-rod end shaft lightly and remove the tie-rod
end from the knuckle.
•
Remove:
Cotter Pins and Front Knuckle Joint Nuts [A]
•
Install a suitable nut [A] (M12) to the knuckle joint end
temporary as shown.
•
Tap [B] the knuckle joint end and remove the joint from
the front suspension arm [C].
•
Install a suitable nut [A] (M12) to the knuckle joint end
temporary.
•
Tap the knuckle joint end and remove the knuckle [B].
Front Knuckle Installation
•
Inspect the spherical bearings in the knuckle joints [A].
If roughness, excessive play, or seizure is found, replace
the knuckle joint.