Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
12-40 FIN AL DRIVE
Front Final Gear Case
Install:
Ring Gear A ssembly
Apply grease to t he O-ring [A] on the front final gear case
center cover.
Install:
Front Final Gear Case Center Cover [A]
Tighten the cover bolts following the tightening sequence
as shown.
Torque - Front Final Gear Case Center Cover Bolts (M8)
[1, 3]: 24 N·m (2.4 kgf·m, 17 ft·lb)
Front Final G ear Case Center Cover Bolts (M6)
[2, 4]: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Adjust the gear backlash and tooth contact pattern (see
Front Final Bevel Gear Adjustment).
Apply a non-permanent locking agent to the cover bolts,
and tighten them to the specified torque in the tightening
sequence [1 4].
Apply a non-permanent locking agent to the pinion gear
bearing holder [A], and tighten it so that the deep recess
[B] faces outward.
Special Tool - Socket Wrench, Hex 41: 57001-1484
Torque - Pinion Gear Bearing Holder: 137 N·m (14 kgf·m,
101 ft·lb)
Install:
Dowel Pins [A]
New Gasket [B]
Steel Balls [C]