Filter
Top Products
13-20 BRAKES
Rear Brake Lever, Pedal and Cables
Brake Pedal Position Inspection
NOTE
○
The position of the brake pedal has been decided by
the position of the adjusting bolt [A].
•
Check that the adjusting bolt is in the correct position as
shown.
Adjusting Bolt Position [B]
Standard: 5 ∼ 6mm(0.20∼ 0.24 in.) (between
Frame and Bolt Head)
If it is incorrect, adjust the adjusting bolt.
Brake Pedal Position Adjustment
•
Remove:
Right Footboard (see Frame chapter)
•
Loosen the locknut [A], and turn the adjusting bolt [B] until
the brake pedal is correctly positioned.
•
Tighten the locknut.
•
Check the brake pedal free play (see Brake Pedal Free
Play Inspection).
Rear Brake Lever Free Play Inspection
•
Refer to the Rear Brake Lever Free Play Inspection in the
Periodic Maintenance chapter.
Brake Pedal Free Play Inspection
•
Refer to the Brake Pedal Free Play Inspection in the Pe-
riodic Maintenance chapter.
Rear Brake Lever and Pedal Free Play Adjustment
•
Refer to the Rear Brake Lever and Pedal Free Play Ad-
justment in the Periodic Maintenance chapter.
Brake Pedal Removal
•
Remove:
Right Footboard (see Frame chapter)
•
Loosen the locknut and the adjusting bolt [A].
•
Remove:
BrakeSwitchSpring[B]
Cotter Pin, Washer, Pin and Brake Cable Joint [C]
Cotter Pin and Washer [D]
O-ring and Brake Pedal [E]
Spring