Filter
Top Products
17-38 ELECTRICAL SYSTEM
Ignition System
Crankshaft Sensor Installation
•
Install:
Stator Coil Leads [A]
Plate [B]
Crankshaft Sensor [C]
•
Tighten:
Torque - Crankshaft Sensor Mounting Bolts: 5.9 N·m ( 0.60
kgf·m, 52 in·lb)
•
Fit the lead grommets into the notch on the alternator
cover.
Grommets [A] for Alternator Leads
Grommets [B] for Crankshaft Sensor Leads
Crankshaft Sensor Inspection
•
Remove the seat (see Frame chapter).
•
Disconnect the crankshaft sensor lead connector [A].
•
Measure the crankshaft sensor resistance.
○
Connect a hand tester between the BK/W lead and the
BL lead.
○
Set the tester to the × 100 Ω range.
Crankshaft Sensor Resistance
423 ∼ 517 Ω
If the tester does not read as specified, replace the crank-
shaft sensor.