ELECTRICAL SYSTEM 17-47
Electric Starter System
Starter Motor Assembly
•
Replace the O-rings.
•
Install the brush plate assembly to the right end cover
so that the projection [A] on the brush plate fits into the
groove on the right end cover.
•
Install the O-ring, insulators [B], and washer [C] in that
order on the terminal bolt.
•
Tighten:
Torque - Starter Motor Termina l Locknut: 6.9 N·m (0. 70
kgf·m, 61 in·lb)
•
Install the washers [A].
•
Install the armature [B] between the brushes.
•
Install the yoke [A] onto the right end cover [B] aligning
the marks [C] on the yoke and right end cover.
•
Install the washers [A].
•
Install the plate [A] on the left end cover [B].