Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
CONVERTER SYSTEM 6-9
Torque Converter
WARNING
Excessive imbalance or operating rpm could cause
torque converter pulley failure resulting in severe
injury or death. The pulleys of the belt drive torque
converter are precision balanced components de-
signed to operate within certain rpm limits. Disas-
sembly/assembly and servicing procedures of the
pulley assemblies must be followed closely. Modi-
fications to the engine or pulleys that increase rpm
may cause failure.
CAUTION
Do not turn the ignition switch OFF position from
ON position, while the torque converter cover is re-
moved.
If it is done, the learning control of Kaw asaki Engine
Brake Control system works and the engine brake
actuator works an error operation.
NOTE
If the drive belt failure detection system is activated by
abnormal belt, the drive belt f ailure detection switch is
damaged. Make sure to replace the torque converter
cover (see Torque Converter Cover Rem oval/Installa-
tion).
Torque Converter Cover Removal
Confirm that the ignition switch is in OFF position.
Remove:
Right Side Cover (see Frame chapter)
Clamp Screws [A] and Clamps
Rubber Air Duct [B]
Remove:
Actuator Lead Connector and Drive Belt Failure Detec-
tion Switch Lead Connector [A]
Torque Converter Cover Bolts [B]
Torque Converter Cover [C ]