Filter
Top Products
FUEL SYSTEM 3-11
Choke Lever and Cable
•
Pull off the retaining clip [A].
•
Fit the cable end [A] in the grommet [B], and free the cable
from the switch case.
•
Pull the cable out of the vehicle.
Choke Lever and Cable Installation
•
Lubricate the choke cable before installation.
•
Install the wave washer, plane washer and screw in that
order.
•
Route the choke cable according to the Appendix chapter.
WARNING
Operation with an incorrectly routed, or damaged
cable could result in an unsafe riding condition.
Choke Cable Lubrication and Inspection
•
Whenever the choke cable is removed or in accordance
with the Periodic Maintenance chart in the Periodic Main-
tenance chapter, lubricate the cable.
•
Refer to the General Lubrication i n the Periodic Mainte-
nance chapter for t he cable lubrication and inspection