12-60 FIN AL DRIVE
Rear Axle
•
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
•
Hold the axle at this setting.
Standard Length of Assembling:
Inboard: 174.6 mm (6.87 in.) [A]
•
Open the edge of the boot in order to eqalize the air pres-
sures.
•
Tighten the large band [A].
○
Assemble it the same as the outboard joint boot, noting
this setting;
Maximum Outside Diameter of Band: 79.7 mm (3.14 in.)
(After tightening the outside diameter)
•
While the band is held at the diameter above, tap down
the tangs [A] of the band.