12-18 FIN AL DRIVE
Output Bevel Gears
•
Tap lightly the front end [A] of the output driven bevel gear
shaft using a plastic mallet.
○
The output driven bevel gear shaft assembly comes off
with the housing.
Output Driven Bevel G ear Installation
•
Apply grease:
O-ring [A]
•
Install the output driven bevel gear shaft assembly.
•
Tighten:
Torque - Output Driven Bevel Gear Housing Bolts: 26 N·m
(2.7 kgf·m, 20 ft·lb)
Output Driven Bevel Gear Disassembly
•
Remove:
Output Driven Bevel Gear Housing Assembly (see Out-
put Driven Bevel Gear Removal)
Oil Seal
•
Hold the holder [A] in a vise, and set the housing assembly
[B] on the holder.
Special Tool - Output Shaft Holder: 57001-1570
•
Remove:
Output Shaft Holder Nut [A]
Special Tool - Socket Wrench [B]: 57001-1482
•
Remove the output shaft [A] from the housing [B] using a
press.