Filter
Top Products
15-6 STEERING
Steering
Steering Stem Removal
•
Remove:
Front Fender (see Frame chapter)
Handlebar (see Handlebar Removal)
Cotter Pins and Tie-rod End Nuts [A]
Steering Stem Bearing Joint Bolts [B] (right and left)
CAUTION
Do not loosen the locknuts [C] at the ends of the
tie-rod adjusting sleeve, or the toe-in of the front
wheels will be changed.
•
Flatten out the bended washer [A].
•
Remove:
Steering Clamp Bolts [B]
Steering Clamps [C]
Grease Seals
•
Cut the band [A] and pull the steering stem [B] out of the
frame.
•
Remove:
Cotter Pin [A]
Steering Stem Bottom End Nut [B]
Collar [C]
Steering Stem Bearing [D]
Steering Stem Installation
•
Full grease up the seal grooves [A] in the steering stem
bearing.
•
Install:
Collar
•
Tighten:
Torque - Steering Stem Bottom End Nut: 6 2 N·m (6.3 k gf·m,
46 ft·lb)
•
Bend both ends of the cotter pin.