Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
ELECTRICAL SYSTEM 17-27
Charging System
Alternator Cover Installation
Be sure all of the old gasket has been removed from the
alternator cover and the left crankcase sealing surfaces.
Check that the dowel pins [A] are in place, and fit a new
gasket on the crankcase.
Check that the bearing [B] is in place.
Fit the grommets [A] into the notch in the cover.
Grease the alternator cover oil seal.
Tighten:
Torque - Alternator Cover Bolts: 8.8 N·m (0.90 kgf·m , 78
in·lb)
Check that the O-ring [A] in the collar [B] is in good con-
dition.
Apply grease to the O-ring.
Install the collar on the alternator cover.
Hold the drive pulley with the drive pulley holder [A].
Special Tool - Drive Pulley Holder: 57001-1520
Install the pulley [A] so that the holes of the pulley fit on
thepins[B]ofthecollar.
Tighten:
Torque - Alternator Rotor Bolt [C]: 127 N·m (13 kgf·m, 94
ft·lb)
Install the removed parts (see appropriate chapter).
Pour:
Coolant (see Coolant Change section in the Periodic
Maintenance chapter)
Engine Oil (see Engine Oil Change section in the Peri-
odic Maintenance chapter)