Filter
Top Products
2-18 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Fuel Hose and Connection Inspection
○
The fuel hoses are designed to be used throughout the
vehicle life without any maintenance, however, if the ve-
hicle is not properly handled, the pressure inside the fuel
line can cause fuel to leak [A] or the hose to burst. Check
the fuel hose.
Replace the fuel hose if any fraying, cracks [B] or bulges
[C] are noticed.
•
Check that the hoses are securely connected and clamps
are installed correctly.
•
When installing the fuel hoses, route the hoses according
to Cable, Wire, and Hose Routing section in the Appendix
chapter.
•
When installing the fuel hoses, avoid sharp bending, kink-
ing, flattening or twisting, and route the fuel hoses with a
minimum of bending so that the fuel flow will not be ob-
structed.
Replace the hose i f it has been sharply bent or kinked.
•
Fit the fuel hose [A] onto the fitting fully and install the
plate clamp [B] beyond the raised rib [C].
1 ∼ 2 mm (0.0039 ∼ 0.0078 in.) [D]
○
The hose end must reach the fillet [E] or be as near as
possible to the step [F].
○
Fit the fuel pump inlet hoses onto the Y-joint fully until
each end of the inlet hose touches the second raised rib.
Fuel Hose Replacement
WARNING
Gasoline is extremely flammable and can be ex-
plosive under certain conditions. Turn the ignition
switch OFF. Do not smoke. Make sure the area is
well ventilated and free from any source of flame
or sparks; this includes any appliance with a pilot
light.
•
Remove:
Right Side Cover (see Frame chapter)
Electric Parts Case (see Frame chapter)
Rear Fender (see Frame chapter)
•
Turn the fuel tap to the ON position.