Kawasaki Brute Force 750 4x4i Offroad Vehicle User Manual


 
2-40 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
General Lubrication
Lubrication
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
Lubricate the points listed below with indicated lubricant.
NOTE
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure spray water, perform the general lubri-
cation.
Cables: Lubricate with Cable Lubricant
Brake Cables
Throttle Cable
Choke Cables
Variable Differential Control Cable
Lubricate the cables by seeping the oil between the cable
and housing.
The cable may be lubricated by using a pressure cable
luber with an aerosol cable lubricant.
With the cable disconnected at the both ends, the cable
should move freely [A] within the cable housing.
If cable movement is not free after lubricating, if the cable
is frayed [B], or if the cable housing is kinked [C], replace
the cable.
Points: Lubricate with Grease.
Throttle Inner Cable Ends [A]
Choke Cable Lower End
Brake C able Ends
Variable Differential Control Cable Ends