Filter
Top Products
12-16 FIN AL DRIVE
Output Bevel Gears
•
Hold the output drive bevel gear housing [A] in a vise.
•
Loosen the bevel gear [B] using an Allen wrench about
four rotations.
•
Remove one nut holding bolt, and look at through the
hole.
If the groove of the bevel gear holder nut is not seen,
loosen the other three bolts.
•
Drive the gear shaft end using a copper mallet until the
grooves of the bearing holder nut can be seen again.
•
Retighten the nut holding bolts (4) securely into the
groove of the bevel gear holder nut in the output drive
bevel gear housing.
Special Tool - Nut Holding Bolts: 57001-1481
•
Repeat the above procedure, and remove the bevel gear
from the housing.
•
Remove the bearing holder [A] using the hexagon wrench
[B].
Special Tool - Hexagon W rench, Hex 41: 57001-1491
○
If the holder seems too difficult to break free, apply heat
to softer the locking agent.
•
Remove:
Outer Ball Bearing [A]
Special Tool - Oil Seal & Bearing Remover [B]: 57001-1058
•
Remove:
Output Drive Bevel Gear Holder Nut
Inner Ball Bearing [A]
Special Tool - Oil Seal & Bearing Remover [B]: 57001-1058