Filter
Top Products
CONVERTER SYSTEM 6-19
Drive Pulley
•
Install the spacer.
•
Put the spring [A] in the groove of the spider.
•
Align the arrows [B] on the drive pulley cover and spider.
•
Install:
Dowel Pins [C]
Drive Pulley Cover
•
Tighten:
Torque - Drive Pulley Cover Bolts: 13 N·m (1.3 kgf·m, 113
in·lb)
•
Clean the surface of the sheaves with an oil-less cleaning
fluid.
Drive Pulley Installation
•
Clean the following portions with an oil-less cleaning fluid
such as trichloroethylene or acetone.
Fixed Sheave Tapered Portion [A]
Crankshaft Tapered Portion [B]
WARNING
These cleaning fluids are usually highly flammable
and harmful if breathed for prolonged periods. Be
sure to heed the fluid manufacturer’s warnings.
•
Install the drive pulley, stepped waster and two washers
on the drive pulley bolt as shown.
Crankcase Side [A]
Stepped Washer [B]
Two Washers [C]
Bolt Head Side [D]
•
Remove the three cover bolts [A] and install the drive pul-
ley holder [B].
Special Tool - Drive Pulley Holder: 57001-1520
•
Tighten:
Torque - Drive Pulley Cover Bolts: 13 N·m (1.3 kgf·m, 113
in·lb)
Drive Pulley Bolt [C] (new, left-hand threads): 93
N·m (9.5 kgf·m, 69 ft·lb)