Filter
Top Products
STEERING 15-7
Steering
•
Apply a non-permanent locking agent:
Steering Stem Bearing Joint Bolts [A]
•
Tighten:
Torque - Steering Stem Bearing Joint Bolts: 23 N·m (2.3
kgf·m, 17 f t·lb)
•
Apply Amoco Rykon Premium Grease No.2 EP (Green):
Inside of Steering Clamp [A]
Oil Seals [B]
•
Install:
Collars [A]
•
Apply above grease to the inside of steering clamp [B].
•
Tighten:
Torque - Steering Stem Clamp Bolts [A]: 25 N·m (2.5 kgf·m,
18 ft·lb)
Tie-rod End Nuts: 42 N·m (4.3 kgf·m, 31 ft·lb)
•
Bend the tabs of the washer [B] toward the bolt head.
•
Inspect the toe-in (see Wheels/Tires chapter).
Front Knuckle Removal
•
Remove:
Front Wheel and Hub (see Wheel/Tiers chapter)
Brake Caliper (see Brakes chapter)
Cotter Pin [A]
CAUTION
Do not loosen the locknuts [B] at the ends of the
tie-rod, or the toe-in of the front wheels will be
changed.